User's Manual
Table Of Contents
- User Guide
- Introduction
- Front
- Back
- User guide symbols
- Getting started
- Compatible chargers
- Charging
- Adding the headset to the phone (pairing)
- Preparing the headset
- Turning the headset on (and off)
- Putting the headset on
- Calling
- Range
- Making a call
- Answering a call
- Ending a call
- Rejecting a call
- Using voice commands
- Making a call using voice commands
- Transferring a call
- Turning the microphone off (and on) during a call
- Settings
- Adjusting ring volume (in standby mode)
- Adjusting speaker volume (during a call)
- Master reset
- Attaching the strap
- Viewing regulatory information
- Troubleshooting
D
r
a
f
t
f
o
r
Son
y
E
r
icsson Inte
r
nal Use Onl
y
-PE1
34
No connection between headset and phone
Make sure the headset is charged and within
range of the phone (see page 8 and 20). Check or
redo the Bluetooth settings in the phone. Try to pair the
headset again.
For more information on Bluetooth and pairing, go to
www.sonyericsson.com/learnabout
The headset is automatically switched off
• The battery is too low. Charge the headset (see page 8).
• The headset switches off if you do not add it to the phone
within 10 minutes. Prepare the headset again (see page
15).
Unexpected behaviour
Do a master reset (see page 29). After a master reset the
headset is reset to factory settings and the paired
Bluetooth devices are removed from your phone.
Battery capacity
A battery that has been infrequently used or a new one,
could have reduced capacity. It may need to be charged/
discharged a number of times (see page 8).