User's Manual

Printed in China
Sony Ericsson Mobile Communications AB
S-221 88 Lund, Sweden
1231-5025.1
www.sonyericsson.com
Stereo Streaming
Bluetooth™
Headset MH110
1. Microphone
2. Call key
3. 3.5 mm audio connector
4. Touch area for Volume/Select
5. On/off key
6. Charger connector
7. Next/Play-pause/Previous keys
8. Display
Introduction
The Stereo Streaming Bluetooth Headset MH110 lets you stay
in control of your incoming and outgoing phone calls. You can
enjoy stereo audio from a phone or other Bluetooth device,
such as a computer or a portable music player. During calls,
the music automatically pauses and starts playing again when
the call ends.
Pairing the headset
The MH110 is already pre-paired with the phone it is shipped
with. The MH110 and the phone connect automatically the fi rst
time you turn on the headset.
Pairing the headset with another device
In order to use the headset with another device you need to
pair the headset with that device. After successful pairing, the
headset connects automatically to the other device as soon as
the headset is turned on and within range.
To pair the headset with another device
1. Make sure the headset is turned off.
2. Turn on the Bluetooth function in the other device.
For instructions, see the user guide of the other device.
3. Place the other device within 20 cm (8 inches) of the
headset.
4. Press and hold down the on/off key on the headset for
about 5 seconds until the pairing indicator appears on the
display.
5. In the other device: Search for and add a new device.
6. If a passcode is requested then enter 0000.
7. The paired device list is shown shortly when successfully
paired.
Note: The headset turns off if you do not pair it with the
device within 10 minutes.
Adjusting the volume
To adjust voice or music volume
1. Enable volume control by swiping the whole touch area
2. Swipe the touch area again to adjust the volume.
For repeated volume adjustment hold down your fi nger at the
end of the touch area after a swipe.
Calling
To make a call
• Dial the number using the phone keys. The call is
automatically activated in the headset.
To end a call
• Press the call key.
To make a call using voice commands
• Press the call key, wait for a beep and then say the
command.
To answer a call
• Press the call key.
To reject a call
• Press and hold down the call key until you hear a beep.
To re-dial a number
• Double-click the call key.
To answer a second call
• Press the call key. The ongoing call is put on hold.
To switch between two calls
• Press and hold down the call key until you hear a beep.
Note: During a call the total call time is indicated on the
display.
Charging
• Before using the headset for the fi rst time, charge it with the
supplied charger for 8 hours.
• The normal charging time is 2.5 hours.
• It is not possible to use the headset during charging.
Turning on and off
To turn on the headset
• Press and hold down the on/off key until sony ericsson
appears on the display.
To turn off the headset
• Press and hold down the on/off key until sony ericsson
disappears from the display.
Display information
• Battery status. Animated when charging
•
The headset is on
•
The headset is ready to be paired with another device
•
Incoming call
•
Outgoing call
•
Ongoing call
•
Voice activated dialing is on
•
Connecting to a phone or other device
•
Adjusting the ringtone volume
(in standby) or the music volume (in music mode)
•
Adjusting the voice volume
•
Streaming device selection menu
•
Calling device selection menu
•
Music mode selection menu
• Normal mode
• Music mode
2
4
5
6
3
8
7
1
2 3 4 5
6 7
8
9