User's Manual

197
Settings
❖
Information
･
In Step 1, tap , then tap [Advanced] to enable/
disable Auto IP support or check "MAC address" and
"IP address".
Mark "Avoid poor connections" to use LTE/WCDMA/
GSM network mode when Wi-Fi radio waves are
weak.
Changing Wi-Fi sleep policy
You can choose to disable the Wi-Fi function
in the terminal when the screen backlight
turns off. You can also set the terminal to
always turn on the Wi-Fi function or to always
turn it on when the terminal is charged.
1
From the Settings screen (P.193),
tap [Wi-Fi].
2
Tap and [Advanced].
3
Tap [Keep Wi-Fi on during sleep].
4
Tap any of [Always]/[Only when
plugged in]/[Never (increases data
usage)].
❖
Information
･
When a Wi-Fi network is disconnected, connection is
automatically switched to a LTE/WCDMA/GSM
network mode.
Using Wi-Fi Direct compatible device
You can connect among the devices
compatible with Wi-Fi Direct via Wi-Fi even
without configuring access point.
･
You need to turn on the Wi-Fi setting
beforehand (P.194).
1
From the Settings screen (P.193),
tap [Wi-Fi].
2
Tap and [ Wi-Fi Direct].
･
A list of detected Wi-Fi Direct devices
appears.
3
Select a Wi-Fi Direct compatible
device name to connect.
･
If a note appears, tap [OK].
･
Tap [Search for devices] to refresh the
detection list.
･
To change the terminal name displayed
on the detected Wi-Fi Direct
compatible device, tap [Rename
device].
❖
Information
･
To use the Wi-Fi Direct function, you need an
application compatible with Wi-Fi Direct function.
The function becomes available when you install a
compatible application.
･
If you start Wi-Fi Direct connection during Wi-Fi
connection, Wi-Fi connection is disconnected and
switched to packet communication (LTE/WCDMA/
GSM).