Instruction Manual
Table Of Contents
- Notes on using your camera
- Table of Contents
- Preparing the camera
- Before your operation
- Shooting images
- Using the shooting function
- Selecting the focus method
- Detecting faces
- Using the flash
- Adjusting the brightness of the image (Exposure, Flash compensation, Metering)
- Shooting with fixed brightness (AE Lock)
- Using brightness compensation for the entire image (Exposure compensation)
- Adjusting the amount of flash light (Flash Compensation)
- Selecting the flash control mode to set the amount of flash light (Flash control)
- Selecting the method for measuring the brightness of a subject (Metering Mode)
- Setting ISO
- Compensating for the brightness and contrast automatically (D-Range)
- Image processing
- Adjusting the color tones (White balance)
- Selecting the drive mode
- Using the viewing function
- Changing your setup
- Viewing images on a computer
- Printing images
- Others
- Index
38
To clean the image sensor using a blower
If another cleaning is needed after using the cleaning mode, clean the image
sensor using a blower following the steps below.
4 Select [Enter] with v, and press the center of the control
button.
The image sensor vibrates for a short time, and eliminates dust from the
sensor.
5 Turn off the camera.
1 Perform the cleaning operation described in steps 1 to 4 of “To
clean the image sensor automatically using the cleaning mode
of the camera.”
2 Detach the lens (page 28).
3 Push the V mark on the mirror
lock lever with a finger to lift up
the mirror.
• Be careful not to touch the surface of
the mirror.
Mirror lock lever