User's Manual
28
Connecting a DVD Player with S Video and Audio
Connectors
Use this hookup if:
•Your DVD player does not have component (Y, P
B, PR) jacks.
Tip
If your DVD player has component video output connectors, for best picture quality, use the
connection described on page 27.
The Y, PB and PR jacks on your DVD player are sometimes labeled as Y, CB and CR, or Y, B-Y
and R-Y. If so, connect the cables to the matching colors.
Disconnect all power sources before making any connections.
1 Using an AUDIO cable, connect the DVD player’s AUDIO OUT jacks to
the TV’s AUDIO IN jacks.
2 Using an S VIDEO cable, connect the DVD player’s S VIDEO OUT jack
to the TV’s S VIDEO IN jack (VIDEO IN 1 or 3).
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make
sure “Auto YC” in the
(Setup) menu is set to “On” to view the S VIDEO input (see page
23).
Tips
• You can also use the VIDEO IN 2 jacks located on the front of the TV to connect your
DVD player.
• To take advantage of the Wide Screen Modes, set the aspect ratio of the output signal to
16:9 on your DVD player. For details, refer to the operating instructions supplied with your
DVD player.
• Use VIDEO 1/2/3 on the remote control to switch to the DVD player input.
• If your DVD player is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of
the S VIDEO cable.
HD/DVD IN
AUDIO OUT
(VAR/FIX)
P
R
P
B
Y
CENTER SPEAKER
IN
180W (6 ) MAX
VIDEO IN
1
S VIDEO
VIDEO
AUDIO
L(MONO)
R
AUDIO
L
R
AUDIO
L(MONO)
R
3 4
S VIDEO cable
(not supplied)
DVD player
AUDIO cable
(not supplied)
Rear of TV
S VIDEO
AUDIO-R
(red)
AUDIO-L
(white)
VIDEO
(yellow)