Instruction Manual

148
Apps
Please note the following when holding the
terminal over an IC card reader or NFC
module equipped device.
･
Bring mark close to the device slowly
without hitting it strongly.
･
Hold mark over the center of the device in
parallel. If scanning fails even with it held over
the center of the scanner, slightly lift up the
terminal, or move it backwards/forwards or to
the left/right.
･
If there is any metal object between mark
and the other device, scanning may fail.
Putting the terminal into a case or cover may
affect communication. In that case, remove
the case or cover.
To use the Osaifu-Keitai compatible service,
set services in the Osaifu-Keitai application.
Turn on NFC function in advance (P.212).
1
From the Home screen, [apps
folder]
u
[Osaifu-Keitai].
･
If the initial settings are not complete,
the initial setting screen appears.
Follow the onscreen instructions.
2
Select a service.
3
Set the service.
･
Set it from the service application or the
website.
4
Hold mark of the terminal over
an IC card reader.
❖
Information
･
You can use the service by holding over an IC card
reader without activating Osaifu-Keitai compatible
application.
･
These services are available even when the terminal
is off. However, they may not be available if the
terminal has been off for a long time, the battery is
too low, or while certain period of time after the
powering on the terminal.
Notes on holding over the
device
Using "Osaifu-Keitai
compatible service"