Handbook
Table Of Contents
- Table of Contents
- Basic operations
- Advanced operations
- Preparation
- Shooting
- Selecting the shooting mode
- Movie recording setup
- Adjusting the focus
- Detecting faces
- Adjusting the brightness of the image
- The flash
- Setting ISO
- Compensating for the brightness and contrast automatically (D-Range)
- Setting the image processing
- Adjusting the color tones (White balance)
- Zooming in in one step
- Selecting the drive mode
- Playback
- Setup of the camera
- Computer
- Cleaning
- Trouble shooting/Others
- Index
185
Cleaning the image sensor
Cleaning (Advanced operations)
If another cleaning is needed after using the cleaning mode, clean the image
sensor using a blower following the steps below.
4 Select [Enter] with v, and press the center of the control
button.
The image sensor vibrates for a short time, and eliminates dust from the
sensor.
5 Turn off the camera.
Cleaning the image sensor using a blower
1 Perform the cleaning operation described in steps 1 to 4 of
“Cleaning the image sensor automatically using the cleaning
mode of the camera.”
2 Detach the lens (page 26).
3 Push the V mark on the mirror
lock lever with a finger to lift up
the mirror.
• Be careful not to touch the surface of
the mirror.
Mirror lock lever