Airpeak Gimbal Setting Guide (GBL-T3)

Control cable
Note:
Pull out this
lock while
pinching
the top and
bottom.
1
3
Fig.1
Fig.2
5
Airpeak gimbal setting guide
I
Calibration 14
Calibrating the Acceleration of the IMU sensor
Prepare a stand to keep the gimbal horizontal level at 2.75in - 4in (7cm - 10cm) height
1
Control cable needs to be disconnected during the calibration. With the power source
of Airpeak turned o, disconnect one side of the control cable. (Fig.1)
2
Turn the aircraft on.
3
Connect the gimbal to PC with supplied microUSB cable. (Fig.2)
4
Run “gTuneDesktop”, select “Gremsy T3” in the menu, then press the “CONNECT”
button in the bottom right.
5
Screen will be switched to “SETTINGS” as the connections
are done, then press “IMU” tab. Select “ACCEL”.
6
Press “POWER” to turn the gimbal o.
5
6