Operating Instructions Super Audio CD/DVD RECEIVER AVD-S10

To avoid short-circuiting the speakers

Short-circuiting of the speakers may damage the receiver. To prevent this, be sure to follow

these precautions when connecting the speakers. Make sure the bare wire of each speaker cord

does not touch another speaker terminal or the bare wire of another speaker cord.

Examples of poor conditions of the speaker cord

After connecting all the components, speakers, and AC power cord (mains lead), output a test

tone to check that all the speakers are connected correctly. For details on outputting a test tone,

see page 26.

If no sound is heard from a speaker while outputting a test tone, or a test tone is output from a

speaker other than the one currently displayed on the front panel display, the speaker may be

short-circuited. If this happens, check the speaker connection again.

Notes

• Be sure to match the speaker cord to the appropriate terminal on the components: 3 to 3, and # to #. If the

cords are reversed, the sound will be distorted and will lack bass.

• If you use front speakers with low maximum input rating, adjust the volume carefully to avoid excessive output

on the speakers.

Stripped cords are touching

each other due to excessive

removal of insulation.

Stripped speaker cord is

touching another speaker

terminal.