Operation Manual

53
GB
BDV-N9100W/BDV-N9100WL/BDV-N8100W/BDV-N7100W/BDV-N7100WL
4-456-335-12(1)
D:\NORM'S JOB\SONY HA\SO130019\BDV-N9100W (PMRF
01)\4456335121_GB (CE)\080OTH.fm
masterpage: Right
Other Operations
3 Press V/v to select [Remote
Control Setting Guide], then
press .
4 Press V/v to select [Preset
Mode], then press .
5 Press V/v to select the
equipment type that you want to
operate with the supplied remote
control, then press .
6 Press V/v to select the device’s
manufacturer, then press .
7 Press POP UP/MENU while
pressing TV (for a TV) or STB (for
a cable box, digital satellite
receiver, digital video recorder,
etc.).
8 When the TV or STB button
starts flashing, enter the code on
the TV screen using the number
buttons, then press ENTER.
If you successfully set the code, the TV
or STB button will flash twice slowly.
If the setting is unsuccessful, the TV or
STB button will flash five times
quickly.
• You can exit Preset mode by pressing the TV or
STB button (whichever button is flashing).
• If you do not operate the remote control for
more than 10 seconds during presetting mode,
the remote control exits from presetting mode.
1 While holding down AV ?/1, hold
down
2 –, then press PROG –.
The BD, TV, and STB buttons light up.
2 Release all buttons.
The BD, TV, and STB buttons turn off
and the preset code is cleared. The
remote control returns to its default
settings.
Saving Power in
Standby Mode
Check that you have made the following
settings:
– [Control for HDMI] in [HDMI Settings]
is set to [Off] (page 63).
– [Quick Start Mode] is set to [Off]
(page 64).
– [Remote Start] in [Network Settings] is
set to [Off] (page 65).
Note
Resetting the remote
control