User guide

English
Damage caused from misuse,
abuse or failure to properly
maintain the camera is not
covered by the limited warranty.
When you use this camera
under/near water, carefully read
the section “About water-proof,
dust-proof, and shock-proof
performance of the camera” in
the Instruction Manual and the
instructions below.
On using this camera
under/near water
Make sure that no foreign matter
such as sand, hair, or dirt gets inside
the multi-connector cover.
Do not open the multi-connector
cover with wet or sandy hands.
Closing the covers
Multi-connecter cover knob
Fully close the cover until the yellow
mark under the slide lock can no
longer be seen.



Cleaning after using the
camera under/near water
Always clean the camera with
water after use within 60 minutes.
Always clean the camera with water
after use, and do not open the multi-
connector cover before cleaning is
finished. Place the camera in fresh
water for about 5 minutes. Then,
gently shake the camera underwater
while pressing each button
repeatedly to clean away any lodged
salt, sand or other matter.
Remove any remaining water or
other foreign matter inside the
multi-connector cover with a soft,
dry cloth.
Do not directly subject the camera to
flowing water such as tap water.
To maintain the water-proof
performance, we recommend that
once a year you take the camera
to your dealer, or to an authorized
repair shop, to have the sealing
gasket of the multi-connector cover
replaced for a fee.



