Installation Manual

Installation manual

1. Mount parts on PCB (including main board & jack PCB)

Main board: top side



Main board: bottom side

For a module with print circuit board antenna, to eliminate the influence from other components or ground,

a clearance area around the print circuit board antenna is necessary, please refer to following picture. In

this area, there should be no metal in it. Besides x-y-axis, there should also be no metal at the Z-axis

direction.

PAGE 1
Installation manual 1. Mount parts on PCB (including main board & jack PCB) Main board: top side Main board: bottom side For a module with print circuit board antenna, to eliminate the influence from other components or ground, a clearance area around the print circuit board antenna is necessary, please refer to following picture. In this area, there should be no metal in it. Besides x-y-axis, there should also be no metal at the Z-axis direction.
PAGE 2
Jack PCB 2. According to the exploded view (refer to final page) to make a complete product. 2a: solder the speaker wire rightly, then install the main board to the PCB holder with screws. 2b: Install the battery pack / NFC module / jack PCB to cabinet rightly.
PAGE 3
2c: Install the main board with speakers. Then connect battery pack / jack PCB / NFC module / microphone.
PAGE 4
2d: Install the speaker holder with screws, then install the speaker grill. 2e: Stick the name plate and date code/serial number on bottom side.
PAGE 5
The END host which install this module should bear the label which display “ contains FCC ID: AK8BM1510 and contient IC : 409B‐BM1510"
PAGE 6