User's Manual
Table Of Contents
- Table of Contents
- Overview
- Location and Function of Parts
- System Configuration
- Installation and Connection
- Operations Using the Supplied Infrared Remote Commander
- Before Starting Operations
- Turning on the Power
- Operating Multiple Cameras Using the Infrared Remote Commander
- Pan/Tilt Operation
- Zoom Operation
- Adjusting the Camera
- Storing the Camera Settings in Memory – Preset Feature
- Storing Camera Pan/Tilt and Zoom Operations – PTZ TRACE function (BRC-X400/X401)
- Operating Menus
- Adjusting and Configuring the Camera through On-Screen Menus
- About On-Screen Menus
- EXPOSURE Menu
- COLOR Menu
- DETAIL Menu
- KNEE Menu (BRC-X400/X401)
- GAMMA/VISIBILITY ENHANCER Menu (BRC-X400/X401)
- VISIBILITY ENHANCER Menu (SRG-X400/X402/201M2/X120/HD1M2)
- ZOOM/FOCUS Menu (BRC-X400/X401, SRG-X400/X402/201M2)
- FOCUS Menu (SRG-X120/HD1M2)
- PICTURE/OPTICAL FILTER Menu
- PAN TILT/PRESET RECALL Menu
- PICTURE PROFILE Menu (BRC-X400/X401)
- VIDEO OUT Menu
- SYSTEM Menu
- PTZ TRACE Menu (BRC-X400/X401)
- STATUS Menu
- Menu Configuration
- Accessing the Camera from a Web Browser
- Operating the Camera from a Web Browser
- Configuring the Camera from a Web Browser
- Basic Operations of the Administrator Menu
- Configuration of the Administrator Menu
- Configuring the System ― System Menu
- Setting the Camera Image ― Video Menu
- Setting the Audio — Audio Menu
- Configuring the Network — Network Menu
- Setting the Security — Security Menu
- Setting the PTZF Control ― PTZF control Menu
- Setting the Streaming — Streaming Menu
- Using NDI|HX
- Appendix
21
Connecting a single camera to a
switcher, recorder, or monitor
Devices equipped with an HDMI input terminal
Devices equipped with an SDI input terminal
(HD output):
BRC-X400/X401
Devices equipped with an SDI input terminal
(HD output):
SRG-X400/X402/201M2/X120/HD1M2
Connecting a single camera to a
single remote controller (not
supplied)
You cannot switch between VISCA over IP and
VISCA RS-422 with the camera. Communication
with the remote controller is possible by
connecting a network cable.
Select either VISCA over IP or VISCA RS-422 with
the remote controller. For details, see the
operating instructions of the remote controller.
Using VISCA over IP (LAN terminal)
Connecting a single camera to a remote
controller directly
* Use a cross network cable.
HDMI cable (not supplied)
To HDMI input terminal
Video monitor
Recorder or monitor equipped with SDI input terminal
Connecting cable with
BNC connector
(commercially available)
To SDI input terminal
SDI OUT
Connecting cable with BNC
connector
(commercially available)
To SDI input terminal
SDI OUT
Recorder or monitor equipped with SDI input terminal
Network cable
(commercially available)
To LAN terminal