User's Manual

29
Storing the Camera Settings
in Memory
– Preset Feature
Settings, including the camera position, zoom,
focus, and backlighting, can be stored in a
preset.
You can also store presets from the Administrator
menu on a web browser. For details, see “Preset
position tab” (page 89).
Notes
The camera supports up to 256 presets. The
number of presets that are supported will vary
depending on the device used.
– For the RM-IP500 (sold separately), up to 100.
– For the RM-IP10 (sold separately), up to 16.
– For the remote commander (supplied), up to 6.
– For a web browser, up to 256 positions.
For details on the camera settings that can be
preset, see “Preset Items and Image Setting File
Items” (page 96).
Storing the camera status
1 Press the PAN-TILT RESET button to reset the
pan/ tilt position.
2 Adjust the position, zoom, and focus of the
camera (See pages 28 and 28).
3 Hold down the PRESET button and press
any of the POSITION buttons, 1 to 6, in
which you want to store the settings.
Note
Before you store the position, zoom, focus, etc.
of the camera, make sure to install and secure
the camera in place to use it properly.
Recalling the stored status
Press any of the POSITION 1 to 6 buttons in which
you have stored the settings.
Clearing the preset memory
Hold down the RESET button and press the
desired POSITION button 1 to 6 for which you
want to clear the settings.
Notes
• If you want to retain the previous pan and tilt
positions when the power is turned off and
turned on again, store those positions in
PRESET 1.
• Storing or clearing the settings in PRESET 1
takes about 2 seconds longer than for other
preset operations.
• When you are storing or clearing the settings in
one PRESET, you cannot restore, store or clear
the settings in another PRESET.
• For details on the items that can be cleared
from the memory, see “Preset Items and Image
Setting File Items” (page 96).
• When [PRESET MODE] is set to [MODE2] in the
SYSTEM menu, only the pan/tilt, zoom, and
focus positions of the camera are recalled
(BRC-X400/X401).
• You can register or delete the preset even while
the menu is being displayed. However, you
cannot perform the pan/tilt operation.
• When [PRESET MODE] is set to [TRACE] in the
SYSTEM menu, the PTZ trace function works
(BRC-X400/X401). For details, see "Storing
Camera Pan/Tilt and Zoom Operations – PTZ
TRACE function (BRC-X400/X401)" (page 30).
• Note that if you change the image flip setting,
the set preset will be cleared.
While holding
down
Press the
POSITION
button you
want to set.
While holding
down
Press the
POSITION
button you
want to clear.