Printer User Manual

41388601TH Rev.2 20 /
(7) Cleaning
Non-fused, residual toner on the OPC drum is scraped with the cleaning blade and collected
in the waste toner area of the toner cartridge.
Cleaning blade
Waste toner box
(8) Cleaning
Residual toner on the transfer belt is scraped with the cleaning blade and collected in the
waste toner box of the transfer belt unit.
Waste toner area
(6) Fusing
When passed between the heat roller and the backup roller, the toner image transferred to
the paper is fused into place by the application of heat and pressure to it.
The Teflon coated heat roller is heated by the built-in heat roller of 800W/backup roller of
500W (halogen lamp). The fusing temperature is controlled by the sum of the temperature
detected by the thermistor moving over the surface of the heat roller and the temperature
detected by the thermistor moving over the surface of the backup roller. A thermostat, which
is provided for safety, becomes open by a heat roller temperature rise of not less than fixed
degrees and cuts off voltage supply to the heater. The backup roller is being pressed against
the heater by the pressure springs on both sides.
Thermistor
Thermostat
Thermistor
Paper
Backup roller
Thermostat
Heat roller