Manual

If you run inte any problem using the camcorder, use the following table to troubleshoot the problem.
Camcorder
Symptom
Tile power is not o11.
The power goes off.
The battery pack is
quickly discharged.
START/STOP does not
operate.
The cassette cannot be
removed from the
= holder.
[ No function except for
i[ cassette ejection works.
O
The tape does not move
when a tape transport
button is pressed
Cause
The battery pack is not
attached or not attached
iirmly.
The battery is dead.
The AC tx)wer adaptor is not
connected to a ,/,,all outlet.
While being operated in
CAMERA mode, the
camcorder has been in the
Standby mode tot more than
5 minutes.
The battery is dead.
The ambient temperature is
too low.
The battery pack has not been
charged fully.
The battery pack is
completely dead, and cannot
be recharged.
The tape is stuck to the drum.
The tape has run out.
The POWER switch is set to
PLAYER.
Fhe tab on the cassette is out
(red)
The battery is dead.
Corrective Actions
Attach the battery pack
firmly by pushing the lower
part of the battery pack.
Use a charged battery pack.
Connect the AC power
adaptor to a wall outlet.
Turn STANDBY down once
and turn it up again.
: The POWER switch is set to
CAMERA or OFF
; The tape has run out.
I You pressed DATE and TIME
together for more than 2
seconds.
Use a charged batlery pack.
Charge the battery pack
again.
Use another battery pack.
Eject the casseHe.
Rewind the tape or use a
new one.
Set to CAMERA.
Use a new cassette or slide
the tab.
Use a charged battery pack
or the AC power adaptor.
Moisture condensation has Remove the cassette and
occurred. " leave thecameorder for at
least an hour.
Set it to PLAYER.
page
10
7
21
7
34
7
35
11
19
t2
t 1
7, 21
38
I9
19
Rewind the tape or use a
new one.
The date or time The camcorder is not
indicator is flashing, malfunctioning. You may
start recording. Flashing will
stop soon.
The date or time Reset the date and time
33
indicator disappears.
(to be continued)
C
g
-<
3
8
a
rD
43