Manual

Remote Control Direction
Aim the Remote Commander to the remote sensor within the range as shown below,
Notes on the Remote Commander
• Keep the re=note sensor away from slrong light sources such as direct sunlight or illumination.
Otherwise, the remote control may not be effective.
• Be sure that there is no obstacle betwc'en the remote sensor and the Remote Commander.
• This camcord_e r works at commander mode VTR 2. The commander modes (1, 2, and 3) are used to
distinguish this camcorder from other Sony VCRs to avoid remote control misoperation. If you use
another Sony VCR at commander mode VTR 2, we recommend you change the commander mode or
cover the remote sensor of the VCR with black paper.
To Watch the Demonstration
You can watch a brief demonslration of pictures with titles,
If the demonstration appears when you turn on the camcorder for the first time, exit the Demo mode to
use your camcorder.
To enter Demo mode
(1) Eject the cassette and turn the POWER switch to OFF.
(2) Turn STANDBY up.
(3) While holding down liP- PLAY, turn the POWER switch to CAMERA. Demonstration starts. The
demonstration stops when you insert the cassette.
Note that once you enter Demo mode_ this mode is retained as long as the lithium battery is in place.
Therefore, demonstration starts automatically ]0 minutes later every time you turn the POWER switch to
CAMERA, or after you eject the cassette.
To exit Demo mode
(1) Turn the POWER switch to OFF.
(2) Turn STANDBY up.
(3) While holding down • STOP, turn the [K)WER switch to CAMERA.
53