User Guide

13
Actual total number: Sony CDX-C810DSP (E) 3-856-118-41 (2)
EN
Adjusting the turn-over frequency
You can adjust the bass and treble turn-over
frequencies.
1 Press (SOURCE) to select a source (radio,
CD or MD).
2 Press (SOUND) repeatedly until “BAS” or
“TRE” appears.
3 Press (SOUND) for two seconds.
Bass adjust mode
Treble adjust mode
4 Press (+) or (–) to select the turn-over
frequency.
The turn-over frequencies change as
follows:
Bass:
125 Hz n 157 Hz* n 198 Hz
Treble:
5.0 kHz n 7.1 kHz*
* Factory-set frequency
5 Press (SOUND) for two seconds.
To adjust the volume of the bass and treble,
press (1) (N).
Listening to each program
source in its registered
surround mode
— Source Sound Memory
You can listen to the same source always in the
surround menu and sound characteristics
(bass, treble and subwoofer) even after
changing the program source or turning the
unit on and off again.
Note
If the optional TV tuner is connected, “LSM” (Last Sound
Memory) appears on the TV display.
4 Press (+) or (–) to select the desired cut-
off frequency.
62 Hz n 99 Hz n 125 Hz* n 157 Hz n 198 Hz
* Factory-set frequency
5 Press (SOUND) for two seconds.
To adjust volume of the subwoofer, press
(1) (N).
Adjusting the volume of
the bass and treble
— Digital Tone Control
The CDX-C810DSP has a built-in DSP IC that
uses digital processing to create clearer
adjustments to the bass and treble volume than
analog circuits.
The sharper tone slopes used in this unit
produce more obvious and effective tone
responses. For example, you can enhance the
background music with the bass volume and
effectively isolate the main vocals.
1 Press (SOURCE) to select a source (radio,
CD or MD).
2 Press (SOUND) repeatedly until “BAS” or
“TRE” appears.
3 Press (+) or (–) to adjust the volume.
After three seconds, the display goes back
to the normal playback mode.
DSP
Frequency (Hz)
SUR EQ
157Hz
BAS
SUR EQ
7.1kHz
TRE