User guide

15GB
RDS
The SEEK starts after a few seconds of
listening.
 The station is non-TP or has weak signal.
 Deactivate TA (page 7).
No traffic announcements.
 Activate TA (page 7).
 The station does not broadcast any traffic
announcements despite being TP.
 Tune in another station.
PTY displays [- - - - - - - -].
 The current station is not an RDS station.
 RDS data has not been received.
 The station does not specify the program
type.
Program service name flashes.
 There is no alternative frequency for the
current station.
 Press SEEK +/– while the program service
name is flashing. [PI SEEK] appears and the
unit starts searching for another frequency
with the same PI (program identification)
data.
CD playback
The disc does not play back.
 Defective or dirty disc.
 The CD-R/CD-RW is not for audio use
(page 12).
MP3/WMA files cannot be played back.
 The disc is incompatible with the MP3/WMA
format and version. For details on playable
discs and formats, visit the support site.
MP3/WMA files take longer to play back than
others.
 The following discs take a longer time to start
playback.
 A disc recorded with a complicated tree
structure.
 A disc recorded in Multi Session.
 A disc to which data can be added.
The sound skips.
 Defective or dirty disc.
USB playback
You cannot play back items via a USB hub.
 This unit cannot recognize USB devices via a
USB hub.
A USB device takes longer to play back.
 The USB device contains files with a
complicated tree structure.
The sound is intermittent.
 The sound may be intermittent at a high-bit-
rate of more than 320 kbps.
Error displays/Messages
ERROR
 The disc is dirty or inserted upside down.
 Clean or insert the disc correctly.
 A blank disc has been inserted.
 The disc cannot play due to a problem.
 Insert another disc.
 USB device was not automatically recognized.
 Connect it again.
 Press  to remove the disc.
HUB NO SUPRT (hubs not supported)
 USB hub is not supported on this unit.
NO AF (no alternative frequencies)
 There is no alternative frequency for the
current station.
 Press SEEK +/– while the program service
name is flashing. The unit starts searching
for another frequency with the same PI
(program identification) data ([PI SEEK]
appears).
NO DEV (no device)
 [USB] is selected as source without a USB
device connected. A USB device or a USB
cable has been disconnected during
playback.
 Be sure to connect a USB device and USB
cable.
NO MUSIC
 The disc or USB device does not contain a
music file.
 Insert a music CD.
 Connect a USB device with a music file in it.