Manual
10Connect the calibration mic to the
A.CAL MIC jack on the front panel and
press .1"/4,to select [YES], then press
®.
Set up the calibration mic at the ear level
using a tripod, etc. (nut supplied). The li'ont
of each speaker shuuld litce the calibratiun
mic, and there should be no obstruction
between the speakers and the calibration
mic. Be quiet during the measurement.
• Avoid being in the measurement area and
making noise during the measurement (which
takes about 1 minute), as itmay interim:rewith
llleas/irement.
11Unplug the calibration mic and press <-/
-> to select [YES].
Quick Setup is linished. All connections
and setup operations are complete.
Calibration mic
m
• Reflections from walls or the floor may affect
nleasurements.
• If measurement fails, follow the message then
retry [AUTO CALIBRATION1.
To quit the Quick Setup
Press C2_DISPLAY in an_ Step.
N]
• If you change the position of the speakers, reset the
speaker settings. See "Getting Optimal Surround
Sound ff)r a Room" (page 69) and "Calibratingthe
Appropriate Settings Automatically" (page 71).
• If you want to change any of the settings, see "Using
the Setup Display" (page 73).
To recall the Quick Setup display
1 Press O DISPLAY when the system is in
stop mode.
The Control Menu appears.
2 Press .1-/4,to select [SETUP], then
press @.
The options for ISETUP] appear.
Auto (alibralion slarls.
m
• Loud test sound is output when [AUTO
CALIBRATION] starts. You cannot turn the
volume down. (live consideration to children
and neighbor.
3 Press -1'./4,to select [QUICK], then press @.
The Quick Setup display' appears.
1gus