User manual

76
Storing the settings for
individual discs
(Disc Memory)
The recorder is factory set to
automatically store settings for each disc.
The recorder automatically stores the
settings for a disc and retrieves them
whenever the disc is inserted.
The following setting can be stored:
• Program play
• Bookmark
• “Custom1” and “Custom2” settings of
6-Band Equalizer
You can check the setting as follows.
1 Remove the disc from the recorder,
enter the menu and select “Option” -
“Disc Mem”.
2 Slide the jog lever repeatedly until
“On” appears in the display, and then
press the jog lever to enter the
selection.
To set the recorder so that
disc settings are not stored
Select “Off” in step 2.
Erasing the disc information
1 Insert the disc whose information is
to be erased and verify its contents.
2 Select “1MemErase” in step 2.
The disc information is erased.
z
When “Disc Mem” is set to “On”, “Disc Mem”
(“Disc Memory” on the recorder) appears
whenever a disc for which settings have been
stored is inserted.
• Settings for up to 64 discs can be stored. Any
settings stored afterwards will replace the
settings with the lowest frequency of use
among the 64. The numbers of discs that can
be stored depend on the numbers of tracks
recorded on the discs. More tracks recorded
per disc means fewer discs can be stored.
• If you try to erase the disc information of a
disc that have never been stored,
“NoDiscMem” (“NO DISC MEMORY” on
the recorder) appears in the display for a few
seconds.
1 Remove the disc from the recorder,
enter the menu and select “Option” -
“Disc Mem”.
2 Turn the jog dial until “On” appears
in the display, and then press NENT
to enter the selection.
Erasing the disc information
1 Insert the disc whose information is
to be erased and verify its contents.
2 Select “1MemErase” in step 2.
DISPLAY
Jog lever
Notes
On the recorder
5-way control key
(NENT)
NAVI/MENUJog dial