User's Manual

ManualsBrandsSony ManualsPro AudioDWR-R01D/30 Dual Channel Diversity Receiver

Table Of Contents

Band: Selects the frequency band to use.

ANT ATT: Sets the attenuator for the receiver’s antenna

input.

ANT DC Output: Sets the DC power supply for the

antennas connected to the receiver’s ANTENNA a/b IN

connectors.

Diversity: Specifies the receiver’s diversity setting.

• This function is not supported on the DWR-R01D,

DWR-R02D, and DWR-R02DN.

• Some screen displays will change depending on the

[Diversity] setting. For details, see “Effects of the

Diversity Setting on Wireless Studio Displays” on

page 60.

Monitor Mode: Specifies the receiver’s headphone

monitor setting.

This function is not supported on the DWR-R01D,

DWR-R02D, and DWR-R02DN.

Sync Source: Sets the sync signal source for the receiver.

Delay Adjust: Selects whether to correct differences in

audio delay time that may occur between receiver channels

1 and 2.

Alert function settings: Specifies the conditions under

which to light the ALERT indicator on the receiver. You

can select the following conditions as triggers for lighting

the ALERT indicator.

• RF low (RF level too low)

• RF over (RF level too high)

• QL low (QL too low)

• AF Peak (audio output level too high)

• Transmitter Battery low (remaining battery on

transmitter is low)

• Encryption unmatch (password or encryption key for the

encrypted communication function does not match)

• External word sync unlock (external word clock signal

not synchronized)

• Code mode unmatch (codec modes of transmitters and

receivers do not match)

If lighting of the ALERT indicator is disabled for an item,

warning messages will not be displayed in the alert list

under the [Message Log] tab and [RF Chart Grapher] tab

of Wireless Studio for that item. In addition, such items

will not be recorded in the log file.

QL Alert SENS: Specifies the level at which the quality

of the received signal is determined to be low. If the quality

of the received signal drops below the level specified here,

the ALERT indicator of the digital wireless receiver lights.

The QL Alert SENS function is available for the following

receiver versions.

DWR-R01D: Version 1.29 or later

DWR-R02D: Version 1.09 or later

DWR-R02DN: Version 1.14 or later

DWR-R03D: Version 1.00 or later

Lock: Sets the receiver’s setting lock function.

This function is not supported on the DWR-R01D,

DWR-R02D, and DWR-R02DN.

Channel tabs 1/2

Displays setting items that are equivalent to those in the

RECEIVER, TRANSMITTER, and RF REMOTE menus

of the receiver.

For details on the setting items in each menu, refer to the

Operating Instructions supplied with the receiver.

1 [Receiver] menu

BAND: Specifies the frequency band to use.

Notes

Note