User's Manual

ManualsBrandsSony ManualsPro AudioDWR-R01D/30 Dual Channel Diversity Receiver

Table Of Contents

This function is not supported by the DWR-R01D and

DWR-R02D.

GP/CH: Displays the frequency group and channel

configured for the receiver channel.

Frequency: Displays the frequency configured for the

receiver channel.

…: Press this button to display the [Group/Channel

Setting] dialog box. You can select the reception

frequency from the channel plan configured for the

receiver in the [Group/Channel Setting] dialog box.

Active Channel Scan: Press this button to execute the

receiver’s active channel scan function. You can select the

channel for receiving from the detected channels.

Clear Channel Scan: Press this button to execute the

receiver’s clear channel scan function. You can select the

channel for receiving from the detected channels.

Encryption: Configure settings for the receiver’s

encrypted communication function.

Codec mode: Configure settings for the receiver’s codec

mode.

This function is not supported by the DWR-R01D and

DWR-R02D.

BAL Out Level: Configure settings for the receiver’s

analog audio output level.

This function is not supported on the DWR-R01D,

DWR-R02D, and DWR-R02DN.

Main Out Level: Adjusts the receiver’s main out level.

This function is not supported on the DWR-R01D,

DWR-R02D, and DWR-R02DN.

UNBAL Out ATT: Configure attenuator settings for the

UNBALANCED OUTPUT 1/2 connector.

This function is not supported on the DWR-R01D.

Ground Lift: Configure whether to connect the

GROUND (XLR 1 pin) of the BALANCED OUTPUT 1/2

connector to a chassis GROUND. You can avoid hum,

buzz, and other noise caused by GROUND LOOP by

selecting [LIFT] to lift GROUND (XLR 1 pin) from the

chassis GROUND.

This function is not supported on the DWR-R01D.

AF Output: Controls the audio output for the receiver

channel. When [MUTING] is selected, audio output

muting will be enabled for the respective receiver channel.

While muting is enabled, the “muting” indicator on the

AF/PEAK level meter will blink red. When

[UNMUTING] is selected, audio output muting will be

disabled for the respective receiver channel.

This function is available under the following conditions.

DWR-R01D: Version 1.26 or later

DWR-R02D: Version 1.06 or later

Search TX: Makes the screens for transmitters that are

paired with the receiver blink.

• This function is not supported on the DWR-R01D,

DWR-R02D, and DWR-R02DN.

• This function is only available on combinations of 3rd

generation or later digital wireless receivers (such as the

DWR-R03D) and digital wireless transmitters (such as

the DWT-B03R). In addition, when using an RMU-01

for Cross Remote connection, the RMU-01 must be

version 1.27 or later.

2 [Transmitter] menu

Transmitter Type: In online mode, this setting cannot be

changed. Specify the model of the transmitter paired with

the receiver in offline mode.

Transmitter Name: Sets the name for the transmitter.

Power save: Configure settings for the transmitter’s

power-saving function.

RF Power: Configure settings for the transmitter’s

transmitted power.

• If the maximum transmission power setting of the

transmitter is changed, execute pairing. It may not be

possible to set the transmission power using the wireless

remote control function.

• On 3rd-generation or later digital wireless transmitters

(such as the DWT-B03R), [RF Power] cannot be set to a

Note

Notes