User's Manual
Table Of Contents
- Table of Contents
- Features
- Parts Identification
- Preparation
- Setting the Receiving Channel
- Using the Encrypted Transmission Function
- Menu Displays and Detailed Settings
- UTILITY Menu
- RX (tuner) 1/2 Menu
- TX (Transmitter Virtual) 1/2 Menu
- Using the Cross Remote
- Changing the Settings on the Transmitter
- Block Diagram
- Troubleshooting
- Important Notes on Operation
- Specifications
- Carrier Frequencies and Channel Steps
23
Wireless remote
control is not
possible.
Pairing has not been established between the
transmitter and receiver.
Carry out pairing (see page 18).
The receiver is too far from the transmitter for
communication to occur.
Check the condition level. If it is low, decrease the
distance between the transmitter and the receiver.
The transmitter that was paired with the receiver
has been paired with another receiver.
Carry out pairing again with the transmitter that you
want to control.
The software version of the transmitter is not
suitable for use with this receiver.
Refer to the transmitter software compatibility table,
and confirm whether the software version of the
transmitter is suitable for use with this receiver (see
page 24). If it is not suitable, software update is
necessary. Contact your Sony service
representative.
The display is too
dark.
The display brightness is set to low. Adjust the brightness of the display (see page 14).
“USB CONNECT”
appears on the
screen and
reception and
controls are not
possible.
Or there is no audio
output.
The receiver is set to software update standby
mode.
Disconnect the USB device from the USB
connector.
Do not connect any USB devices to the USB
connector other than when updating the software.
Symptom Meanings Remedy