User's Manual

11
• FACTORY PRESET (factory settings) function
• VERSION (software version) display
Menu Settings
This section describes the various setting items and their
values. Underlined values represent factory settings.
Unit Name Setting (NAME)
Specify up to 16 characters for the unit’s name. The
factory setting is the unit’s model name and serial number.
The unit’s name is sent to the receiver as metadata and
used by the receiver to distinguish between different
transmitters.
+ button: Displays the character set. Next, use the + and
– buttons to select a character, and then press the SET
button to add the selected character at the last position of
the current name.
– button: Deletes the last character in the current name.
SET button: Confirms the selected character.
When you are finished editing the name, press the SET
button to confirm it.
You cannot insert or delete characters in the middle of the
name.
The name setting can be changed from the receiver and
other devices via the wireless remote control function.
For details, see “Using Cross Remote” (page 8).
Frequency Band Selection (BAND)
Match the frequency band of the unit with that of the
wireless receiver that will be used with the unit.
The frequency bands that can be set will differ depending
on the models of the unit and the receiver. For details, see
“Carrier Frequencies and Channel Steps” (page 24).
For details on the frequency range of each band, refer to
“Sony Digital Wireless Microphone System Frequency
Lists” on the supplied CD-ROM.
The frequency band setting can be changed from the
receiver and other devices via the wireless remote control
function.
For details, see “Using Cross Remote” (page 8).
• This setting cannot be changed during actual signal
transmission. Turn the unit off, and then hold down the
POWER button while pressing the SET button to turn
the unit on in a state where signals are not transmitted
before changing the setting.
Notes
Notes