Operating Instructions

Parts Identification
7
a ANTENNA a/b connector (BNC type)
Connect the supplied antenna here.
b UNBALANCED OUTPUT AUX/TUNER
(external audio output) connector (headphone
jack)
Connect monitoring equipment and similar peripheral
devices here.
You can configure muting based on your intended use.
For details on settings, see “Configuring the transmitter
muting function for the output connectors” (page 13).
For details on connections, see “System Configuration
Examples” (page 19).
c UNBALANCED OUTPUT MAIN (main audio
output) connector (headphone jack)
Connect a mixer or an amp here.
You can configure muting based on your intended use.
For details on settings, see “Configuring the transmitter
muting function for the output connectors” (page 13).
For details on connections, see “System Configuration
Examples” (page 19).
d BALANCED OUTPUT connector (XLR type)
Connect a mixer or similar device here.
You can configure muting based on your intended use.
For details on settings, see “Configuring the transmitter
muting function for the output connectors” (page 13).
For details on connections, see “System Configuration
Examples” (page 19).
e MIC/LINE (audio output level) selector
Selects the audio output level of the BALANCED
OUTPUT connector. The factory default setting is MIC.
MIC: Sets the audio output level to the mic level.
LINE: Sets the audio output level to the line level.
Do not set the selector to the LINE position while
outputting audio to an audio mixer or similar device.
Inputting audio at excessive levels may distort audio or
damage the playback/recording device.
f Cable clamp
Secures the cable of the supplied AC adapter.
g DC IN 12V (power input) connector
Connect the supplied AC adapter here.
DWZ-B70HL
Body-pack transmitter (transmitter: ZTX-
B02RC)
a Antenna cover
Contains the antenna.
Do not squeeze the antenna cover. Doing so will weaken
the signal that is transmitted, decreasing the transmission
range.
b BATT/CHARGE (remaining battery / charge)
indicator
Lights when the unit is turned on. This indicates the
remaining battery charge or the charge status.
The remaining battery indication only appears when
alkaline dry cell batteries are being used.
c ENCRYPTION switch
Allows you to use the encrypted transmission function.
The factory default setting is OFF.
For details on the encrypted transmission function, see
“Enabling Encrypted Transmission” (page 15).
Caution
Rear
Caution
Indicator Status
Lit (green) Good
Lit (red) Almost dead
Lit (orange) Charging