Operating Instructions
Table Of Contents
- Table of Contents
- Package Contents
- Features
- Parts Identification
- Power Supply
- Attaching the Supplied Accessories
- Receiver Settings
- Transmitter Settings
- Enabling Encrypted Transmission
- Channel Frequency List
- System Configuration Examples
- Troubleshooting
- Important Notes on Use
- Notes on Charging Batteries
- Specifications
Attaching the Supplied Accessories
10
Attaching the Supplied
Accessories
This section describes how to attach the supplied
accessories to each unit.
Attaching the Supplied Accessories
to the Handheld Microphone (ZTX-
M02RC)
Attaching the microphone holder
Replacing the microphone unit
To remove the microphone unit
To attach the microphone unit
Turn the microphone unit in the opposite direction from
when you removed it, and make sure that the unit is
securely attached to the microphone.
Attaching the Supplied Accessories
to the Half-Rack Receiver (ZRX-
HR70)
Attaching the antenna
Removing the feet
Attaching the Supplied Accessories
to the Body-Pack Transmitter (ZTX-
B02RC)
Attaching the belt clip
Insert the bottom part of the
microphone into the holder.
Turn the microphone unit in the direction of the arrow.
Insert the supplied antenna into the
ANTENNA a/b connector at the rear of
the receiver and turn it.
Use a flat-bladed screwdriver or
similar tool to remove the pins that
secure the feet, and then remove the
feet from the half-rack receiver.
Align the mounting hole at the rear of the transmitter with the
hole in the middle of the supplied belt clip, and secure the belt
clip using the supplied belt clip screw.
You can also rotate the belt clip 180 degrees or 90 degrees to
the left or right before securing it.