Operating Instructions
Table Of Contents
- Table of Contents
- Package Contents
- Features
- Parts Identification
- Power Supply
- Attaching the Supplied Accessories
- Receiver Settings
- Transmitter Settings
- Enabling Encrypted Transmission
- Channel Frequency List
- System Configuration Examples
- Troubleshooting
- Important Notes on Use
- Notes on Charging Batteries
- Specifications
Receiver Settings
13
Configuring the effect level
1
In the [Setup] screen, select [Audio Setup].
The [Audio Setup] screen appears.
2
Select [Feedback Reducer].
The [Feedback Reducer] screen appears.
3
Select [Effect Level].
The [Effect Level] screen appears.
4
Select the effect level.
Selecting [High] will increase the acoustic feedback
noise reduction effect. However, audio signal delay
and changes in sound quality will also increase.
Select a setting based on your environment.
Low: Adds about 0.1 milliseconds of delay.
Mid: Adds about 8 milliseconds of delay.
High: Adds about 16 milliseconds of delay.
5
Select [Set].
This completes the configuration, and the main
screen appears again.
Specifying the connectors to which the
intelligent feedback reducer function is applied
1
In the [Setup] screen, select [Audio Setup].
The [Audio Setup] screen appears.
2
Select [Feedback Reducer].
The [Feedback Reducer] screen appears.
3
Select [Apply Feedback Reducer].
The [Apply Feedback Reducer] screen appears.
4
Select the connectors for which you want the
feedback reducer function enabled.
This completes the configuration, and the main
screen appears again.
Configuring the equalizer
Configure the equalizer. Under factory default settings,
the equalizer is set to 0 dB for each frequency and the
function itself is set to [OFF].
1
In the [Setup] screen, select [Audio Setup].
The [Audio Setup] screen appears.
2
Select [Equalizer].
The [Equalizer] screen appears.
3
Select [On] to enable the equalizer function, or [Off]
to disable it.
If you select [On], the equalizer settings screen
appears.
If you select [Off], configuration is complete and the
main screen appears again.
4
Select the frequency for which you want to adjust the
level, and adjust the setting.
5
Select [Set].
The setting value is saved.
To cancel the setting, press the ESC button.
Configuring the transmitter muting
function for the output connectors
You can select whether to enable the muting function
controlled by the transmitter for the audio output of each
output connector. The factory default setting is [To
Balanced & Main Only].
1
In the [Setup] screen, select [Audio Setup].
The [Audio Setup] screen appears.
2
Select [TX Muting].
The [Apply TX Muting] screen appears.
Screen display
Connector
To All
Outputs
To
Balanced
& Main
Only
To AUX/
Tuner
Only
BALANCED OUTPUT
Enabled
Enabled
–
UNBALANCED
OUTPUT MAIN
–
UNBALANCED
OUTPUT AUX/
TUNER
– Enabled