Operating Instructions

Enabling Encrypted Transmission
15
Selecting the channel
1 Press and hold the channel selection button while the
unit is turned on.
The channel display blinks.
2 Press the channel selection button to select the
channel.
3 Press and hold the channel selection button to apply
the channel selection.
If you change the channel setting on the transmitter, be
sure to change the channel setting on the receiver to the
same channel. If the receiver channel and transmitter
channel are not identical, audio will not be output.
Channel Display
Each channel will appear as follows in the transmitter’s
channel display.
Enabling Encrypted
Transmission
Encrypted transmission will only be enabled on
transmitter and receiver pairs for which the following
settings have been configured.
• After encrypted transmission is enabled, the enabled
settings will remain until they are disabled.
• To disable encrypted transmission, disable the settings
on both the transmitter and the receiver.
• If you want to change the transmitter and receiver pair
for which encrypted transmission is used, you must
configure the settings again.
Enabling encrypted transmission
1 Synchronize the transmitter and receiver channels.
For details on configuring the transmitter’s channel
and the receiver’s channel, see “Configuring the
Transmitting Channel Settings” (page 14) and
“Configuring the receiving channel settings”
(page 12) respectively.
2 Set the ENCRYPTION switch on the transmitter to
the OFF position.
Leave the power on.
3 In the [Setup] screen of the receiver, select
[Advanced Settings].
The [Advanced Settings] screen appears.
For details on displaying the [Setup] screen, see
“Displaying the settings menu” (page 12).
4 Select [Encryption].
The [Encryption] screen appears.
5 Set the [Encryption] setting to [On].
6 Within 7 seconds of step 5, set the ENCRYPTION
switch on the transmitter to the ON position.
When the setting is properly enabled, “Complete”
appears on the receiver.
If “Connection Failed” appears on the receiver, the setting
has not been configured properly. Configure the settings
again from step 1.
Caution
RF mode Channel number
Wide Band (WIDE) 1 2 3
4 5 6
Narrow Band (NARROW) a b c
d e f
Notes
Note