User's Guide

103
Chapter 6 Reference
Symptom
Data cannot be written
to the “Memory Stick.”
When the “Memory
Stick” is removed from
the PC, the PC screen
turns blue and
displays a disk-read-
error message.
AIBO is not correctly
rendered in the
Preview Window.
AIBO stops in mid-
movement.
Remedy
• The “Memory Stick” is not inserted correctly.
c Check that the “Memory Stick” is inserted in the drive correctly.
• The “Memory Stick” drive is set incorrectly.
c Set the drive correctly in the AIBO Master Studio Setup
window (page 20).
• System files hasn’t been copied.
c To use a “Memory Stick” with AIBO Master Studio, you need to
copy the appropriate system files for your AIBO to the
“Memory Stick” (page 21).
• The safety switch on the “Memory Stick” is set to LOCK.
c Set the switch on the “Memory Stick” to the write-enable
position (page 105).
• The “Memory Stick” was removed before the PC had completed
writing data on the “Memory Stick.”
c Insert the “Memory Stick” again and press the Enter key; wait a
while then remove the “Memory Stick.”
• The graphic driver is not the latest version.
c The 3D image of AIBO is rendered using OpenGL. OpenGL is
processed with the graphic driver or hardware depending on
the graphic card used. Please contact the manufacturer of your
PC or graphic card.
• A long motion was played back (ERS-210/220).
c If AIBO tries to execute a motion that is longer than 30 seconds,
the motors are strained and AIBO may automatically stop
moving. To return AIBO to normal, press the head sensor for 3
seconds or more for ERS-210, and push the head sensor toward
the front for 3 seconds or more for ERS-220.
• AIBO is heating up.
c The pause light goes off, and AIBO stops moving. Do not move
AIBO until it cools down. When making a program, avoid
arranging strenuous motions one after the other.
• Battery is low
c To be safe, AIBO will stop acting and lie on its stomach. Charge
the battery.