User's Guide

68
Chapter 4 Behavior Arranger
Tail_RollL
If the tail is rolled once to the left, the variable is set
to “1.”
To clear the variable, use the SET command to enter
“0.”
Tail_U_LONG
If the tail is pushed toward the front for three
seconds, the variable is set to “1.”
To clear the variable, use the SET command to enter
“0.”
Tail_D_LONG
If the tail is pushed toward the back for three
seconds, the variable is set to “1.”
To clear the variable, use the SET command to enter
“0.”
Tail_R_LONG
If the tail is pushed toward the right for three
seconds, the variable is set to “1.”
To clear the variable, use the SET command to enter
“0.”
Tail_L_LONG
If the tail is pushed toward the left for three seconds,
the variable is set to “1.”
To clear the variable, use the SET command to enter
“0.”
Tail_U_ON
If the tail is pushed toward the front, the variable is
set to “1.”
To clear the variable, use the SET command to enter
“0.”
Tail_D_ON
If the tail is pushed toward the back, the variable is
set to “1.”
To clear the variable, use the SET command to enter
“0.”
Tail_R_ON
If the tail is pushed toward the right, the variable is
set to “1.”
To clear the variable, use the SET command to enter
“0.”
Tail_L_ON
If the tail is pushed toward the left, the variable is
set to “1.”
To clear the variable, use the SET command to enter
“0.”
RFLeg_ON
When the paw switch on the front right leg is
pressed, the variable is set to “1.”
To clear the variable, use the SET command to enter
“0.”
RFLeg_OFF
The length of time the paw switch on the front right
leg was pressed.
Effective range: 0 to 10,000 Unit: ms
LFLeg_ON
When the paw switch on the front left leg is pressed,
the variable is set to “1.”
To clear the variable, use the SET command to enter
“0.”
LFLeg_OFF
The length of time the paw switch on the front left
leg was pressed.
Effective range: 0 to 10,000 Unit: ms