User's Manual

11
GB
Getting Started
GTK-XB7.4-582-492-11(1)
Getting Started
Inserting batteries
Insert two R03 (size AAA) batteries
(supplied), matching the polarities
shown below.
Notes
• Do not mix an old battery with a new one
or mix different types of batteries.
• If you do not use the remote control for a
long period of time, remove the batteries
to avoid damage from battery leakage
and corrosion.
Turning on the system
1 Connect the AC power cord
(supplied) to the AC IN jack on
the rear of the unit, and then
to the wall outlet.
To wall outlet
AC power
cord
(supplied)
The system is turned on in the
demonstration mode and the
demonstration starts automatically.
2 Press  to turn on the system.
The  indicator lights up in green
and the demonstration ends.
Deactivating the demonstration
Press LIGHT ON/OFF while the
demonstration is performed.
The demonstration ends and the
system enters the standby mode.
When you press LIGHT ON/OFF
during the standby mode, or when
you disconnect and reconnect the AC
power cord, the system enters the
demonstration mode.
Hints
• You can also deactivate the demonstration
using “SongPal.“ For details on “SongPal,“
see “Using “SongPal” via BLUETOOTH”
(page19).
• The system always enters the standby
mode when you turn it off using  on the
remote control.
Carrying the system
Before carrying the system, make
sure that there is no USB device is
connected, and disconnect all the
cords.
Note
Correct hand placement while carrying the
system is very important to avoid personal
injury and/or property damage.