Manual

If the USB device is connected via a
USB hub, disconnect it and connect
the USB device directly to the trait.
• The connected equipment's setting
for the [Control for HDMI] function
is correct.
Thepicture/soundispoor/certain
programsdisplaywitha lossofdetail,
especiallyduringfast-motionordark
scenes.
Picture/sound quality may be poor
depending on [nternet content
providers.
Picture/sound quality may be
improved by changing the connection
speed. Sony recommends a connection
speed of at least 2.5 Mbps for standard-
definition video and 10 Mbps for high-
definition video.
Not all videos contain sound.
Thepictureissmall.
---* Press 4" to zoom in.
The[ControlforHDMI]functiondoes
notwork("BRAVIA"Sync).
Check that [Coutrol for HDM[] is set
to [On] (page 50).
If you change the HDM[ connection,
turn the system off and on again.
If power failure occurs, set [Control
for HDM[] to [Off], then set [Control
for HDM[] to [On] (page 50).
Check the following and refer to the
operating instructions supplied with
the equipment.
• The connected equipment is
compatible with the [Control for
HDM[] function.
Thesystemcannotconnecttothe
network.
---* Check the network couuectiou
(page 21) and the network settings
(page 51 ).
YoucannotconnectyourPCtothe
Internetafter[Wi-FiProtectedSetup
(WPS)]isperformed.
The wireless settings of the router may
change automatically if you use the
Wi-Fi Protected Setup function before
adjusting the settings of the router. In
this case, change the wireless settings
of your PC accordingly.
Thesystemcannotconnecttothe
networkorthenetworkconnectionis
unstable.
---* Check if the wireless LAN router is on.
Check the network connection
(page 21) and the network settings
(page 51 ).
Depending on the usage environment,
including the wall material, radio wave
reception conditions, or obstacles
between the system and the wireless
LAN router, the possible
communication distance may be
shortened. Move the system and the
wireless LAN router closer to each
other.
o.
o
-1
b"
3
o
-1
5gus