User's Manual

Installation Manual

MODEL : SII-SK63101

FCC ID:AK8-HMZ-WM1

IC : 409B-HMZWM1

1. Example of mounting to the final product.

2. Contents of the plan described in the manual of the final product.

For FCC

"Note: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation.

If this equipment does cause harmful interference to radio or television reception, which

Main

board

Cross-section

AV/Power

Cable

RF Board

BB Chip RF Chip

Battery

Module’s shield case

Exterior case (ABS)

Additional shield case / Heat sink

EUT

board

EUT

Heat sink

Connect to

main board

with FPC

Assembly

AV/Power

Cable

Battry

Top cover

EUT

Middle cover

Battery

Bottom cover

Screw

SONY Corp.

PAGE 1
Installation Manual MODEL : SII-SK63101 SONY Corp. FCC ID:AK8-HMZ-WM1 IC : 409B-HMZWM1 1. Example of mounting to the final product.
PAGE 2
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help.
PAGE 3
. Contents of the plan described in the label of the final product. For FCC Label of the end product: For SII-SK63101 module: The final end product must be labeled in a visible area with the following "Contains FCC ID:AK8-HMZ-WM1 ". For IC Label of the end product: For SII-SK63101 module: The final end product must be labeled in a visible area with the following "Contains IC:409B-HMZWM1 ".