Owner's Manual

Help Guide
Flash
HVL-F28RM
Removing/attaching the dust and moisture resistant cover
Depending on the external design of a camera, the dust and moisture resistant cover attached to this flash unit may come in
contact with the camera body, but you can still attach the flash unit to the camera and use it for photography.
To secure the effect of dust and moisture resistance, make sure you attach the cover properly to the flash unit by following these
steps.
To remove the dust and moisture resistant cover
Push down a corner of the dust and moisture resistant cover to take it off of the Multi Interface foot.
To attach the dust and moisture resistant cover
Press and hold the release button and rotate the lock lever away from “LOCK.”
1
Orient the dust and moisture resistant cover with respect to the Multi Interface foot of the flash unit.
2
Attach the dust and moisture resistant cover by tucking its four inner corners into the gap above the Multi Interface
foot.
3
12