IC Recorder Operating Instructions
Table Of Contents
- Checking the contents of the package
- Getting Started
- Basic Operations
- Various Recording Modes
- Manual Recording Mode
- Starting to Record Automattically in Response to Sound – the VOR Function
- Adding a Recording to a Previously Recorded Message
- Adding an Overwrite Recording during Playback
- Dividing a Message into Two during Recording
- Recording with an External Microphone
- Recording from Other Equipment
- Playback/Erasing
- Editing Messages
- Utilizing the Menu Function
- Using the IC Recorder with Your Computer
- Troubleshooting
- Additional Information
ICD-SX57/SX67/SX77 GB 2-894-352-12 (2)
13
GB
Getting Started
Getting Started
Step 1: Preparing a
Power Source
Charging the batteries
To use the supplied Digital Voice Editor
software, it is recommended that you
install the software before step 3.
1 Slide and lift the battery
compartment lid.
2 Insert two rechargeable batteries
with correct polarity, and close the
lid.
3 Charge the batteries by connecting
the USB connector of the IC
recorder to your computer.
USB connecting
cable (supplied)
While the batteries are charging,
“CONNECTING” and the battery indicator
are displayed in an animation.
When the battery indicator indicates
“ ,” charging is completed. (Charging
time: approx. 4 hours*)
When you use the IC recorder for the
rst time, or after you have not used
the IC recorder for a certain time, it
is recommended that you charge
the batteries repeatedly until “ ” is
displayed.