Owner's manual
Table Of Contents
- Checking the contents of the package
- Getting Started
- Basic Operations
- Various Recording Modes
- Manual Recording Mode
- Starting to Record Automattically in Response to Sound – the VOR Function
- Adding a Recording to a Previously Recorded Message
- Adding an Overwrite Recording during Playback
- Dividing a Message into Two during Recording
- Recording with an External Microphone
- Recording from Other Equipment
- Playback/Erasing
- Editing Messages
- Utilizing the Menu Function
- Using the IC Recorder with Your Computer
- Troubleshooting
- Addtional Information
ICD-SX57 GB 2-894-353-52 (2)
14
GB
While the batteries are charging,
“CONNECTING” and the battery indicator
are displayed in an animation.
When the battery indicator indicates
“ ,” charging is completed. (Charging
time: approx. 4 hours*)
When you use the IC recorder for the
rst time, or after you have not used
the IC recorder for a certain time, it
is recommended that you charge
the batteries repeatedly until “ ” is
displayed.
If the battery indicator is not displayed,
charging has not been done properly.
Proceed from step 1 again.
* This is an approximation for the time it takes
to charge from no remaining battery power
to full battery power at room temperature.
It varies depending on the remaining
power and the condition of the batteries.
It also takes more time if the temperature
of the batteries is low, or if the batteries are
changed while you are transferring data to
the IC recorder.
Tip
You can charge the rechargeable batteries by
connecting the IC recorder to an AC outlet
using a USB AC adaptor (not supplied) (page
78).
Notes
While “ ” or “ ” is being displayed
instead of the remaining battery/charging
indicator, you cannot charge the batteries.
Charge the batteries in an environment with
a temperature of 5 °C – 35 °C.
If “USB CHARGE” in the menu “DETAIL
MENU” is set to “OFF,” you cannot charge
the batteries using your computer. Set “USB
CHARGE” to “ON” (page 56).
Do not use manganese batteries for this IC
recorder.
Clock setting display appears when you
insert batteries for the rst time, or when
you insert batteries after the IC recorder
has been without batteries for a certain
period of time. Please refer to step 4 in
“Step 2: Setting the Clock” on page 17 to
set the date and time.