Installation Manual

Installation Description

IRF303J shall be installed in Location Free TV, model: LF-X5.

When IRF303J is installed in a product, we shall consider the following points;

1. Since IRF303J owns its FCC ID Number/IC Number, we shall affix an exterior label on the

outside of the product if the FCC ID/IC Number is not visible. The exterior label shall use

wording such as either "Contains Transmitter Module FCC ID:AK8IRF303J/IC Number:409B-

IRF303J" or "Contains FCC ID:AK8IRF303J/IC Number:409B-IRF303J".

2. IRF303J complies with requirements of sub-sections 15.203, 15.205, 15.207 and 15.247 in

FCC Rules Part 15. We shall install IRF303J in accordance with their requirements. IRF303J

complies with requirements of the sub-section 2.1093. When installers install IRF303J into a

product, they shall ensure that the public is not exposed to radio frequency energy levels in

excess of the Commission’s guidelines in accordance with the sub-section 15.247(b)(5) in FCC

Rules Part 15.

3. Special Accessory (Shielded tape) must be patched for RF inference. Please refer to the

following picture.

Shielded tape Shielded tape

4. IRF303J is to be installed only by the professionals as shown in below figure.

Note: Antenna cable length:

Antenna 1: 5cm Antenna 2: 19cm

ntenna 2

(HFT18)

ntenna 1

(HFT18)

IRF303J

PAGE 1
Installation Description IRF303J shall be installed in Location Free TV, model: LF-X5. When IRF303J is installed in a product, we shall consider the following points; 1. Since IRF303J owns its FCC ID Number/IC Number, we shall affix an exterior label on the outside of the product if the FCC ID/IC Number is not visible. The exterior label shall use wording such as either "Contains Transmitter Module FCC ID:AK8IRF303J/IC Number:409BIRF303J" or "Contains FCC ID:AK8IRF303J/IC Number:409B-IRF303J". 2.
PAGE 2
5. RF exposure requirements: For portable equipment: The available scientific evidence does not show that any health problems are associated with using low power wireless devices. There is no proof, however, that these low power wireless devices are absolutely safe. Low power Wireless devices emit low levels of radio frequency energy (RF) in the microwave range while being used.