5-001-676-11(1) Television Reference Guide Customer Support and Contact: KD-98Z9G / 85Z9G
For information on setting up your TV, refer to the Setup Guide. Introduction Thank you for choosing this Sony product. Before operating the TV, please read this manual thoroughly and retain it for future reference. Note Table of Contents • Before operating the TV, please read the “Safety Information” (page 2). • Read the supplied Safety Information for additional safety information. • Instructions about “Installing the TV to the Wall” are included within this TV’s instruction manual.
• Be sure to use the screws supplied with the Wall-Mount Bracket when attaching the Wall-Mount Bracket to the TV set. The supplied screws are designed as indicated by illustration when measured from the attaching surface of the Wall-Mount Bracket. The diameter and length of the screws differ depending on the Wall-Mount Bracket model. Use of screws other than those supplied may result in internal damage to the TV set or cause it to fall, etc.
KD-85Z9G Please refer to below illustration for M8 eye bolt length. 12 mm - 16 mm 4 mm - 7 mm 1.5 N·m {15 kgf·cm} M8 eye bolt M4 screw (not supplied) TV’s rear cover Ventilation • Never cover the ventilation holes or insert anything in the cabinet. • Leave space around the TV set as shown below. • It is strongly recommended that you use a Sony Wall-Mount Bracket in order to provide adequate air circulation.
Parts and Controls Controls and Indicators ȩ ̕ (Power) / + / – When the TV is off, Press to power on. When the TV is on, Press and hold to power off. Press repeatedly to change the function, then press + or – button to: • Adjust the volume. • Select the channel. • Select the input source of TV. Remote Control sensor*1 / Light sensor*1 / Illumination LED The illumination LED lights up or blinks according to the status of the TV. For more information, refer to the Help Guide.
Using Remote Control Remote Control Parts Description The remote control shape, location, availability and function of remote control buttons may vary depending on your region/country/TV model. (Microphone) Use voice search*. (e.g., Search various content by voice.) MIC //// (Navigation D-Pad) On screen menu navigation and selection. TV Switch to a TV channel or input and display the TV menu. * (TV standby) Turn on or turn off the TV (standby mode).
GUIDE/ Display the digital programme guide, or EPG of cable/satellite box after setting [Cable/Satellite box setup] (Set top box control compatible models only). APPS Display a list of installed apps. (Input select) /// Operate media contents on the TV and connected BRAVIA Sync-compatible device. EXIT Return to the previous screen or exit from the menu. When an Interactive Application service is available, press to exit from the service. / Display and select the input source, etc.
Attaching the Floor Stand (KD-98Z9G only) 1 Lift up the TV. 2 Attach the Floor Stand to the TV. Your TV is shipped with Table-Top Stand attached to the TV. Recommended Refer to the instructions below on how to change the Table-Top Stand to Floor Stand. Note • Do not put stress on the LCD panel or the frame around the screen. • Be careful to not pinch your hands or the AC power cord (mains lead) when you install the TV set to the Floor Stand.
3 Support the Floor Stand while attaching them to the TV using the supplied screws M6L23 to avoid dropping. • Five or more people are needed to transport a large TV set. M6L23 Note • If using an electric screwdriver, set the torque at approximately 1.5 N·m {15 kgf·cm}. 4 Remove screws from Table-Top Stand. Note • When reassemble the Table-Top Stand, make sure it matches the screw holes.
Bundling the cables (KD-98Z9G only) 2 Note • Do not bundle the AC power cord (mains lead) together with other cables. 1 ʓ 3 ʔ CC CA Note • To open the cable clamper for bundling the cables, press the side of the clamper , then open as illustrated.
4 5 11GB
Connection Diagram For more information on connections, refer to the Help Guide by pressing HELP on the remote control.
/ VIDEO IN • For a composite connection, use an Analogue Extension Cable (not supplied). • 3.5 mm 1: L 2: Video 3: Ground 4: R 1 2 3 4 • HDMI IN 3 eARC/ARC (Enhanced Audio Return Channel/ Audio Return Channel) Connect your audio system to the HDMI IN 3 to route TV audio to your audio system. An audio system that supports HDMI eARC/ARC can send video to the TV, and receive audio from the TV via the same HDMI cable.
Installing the TV to the Wall This TV’s instruction manual only provides the steps to prepare the TV for Wall-Mount installation before it is installed on the wall. To Customers: For product protection and safety reasons, Sony strongly recommends that installation of your TV be performed by Sony dealers or licensed contractors. Do not attempt to install it yourself.
KD-85Z9G only 1 Remove the stand cover and terminal covers. ʕ ʓ ʓ ʔ ʔ 2 Remove the screws from the rear of the TV.
The remote control does not function. Troubleshooting General troubleshooting for issues like: black screen, no sound, frozen picture, TV does not respond, or network is lost, do the following steps. Replace the batteries. The parental lock for broadcast password has been forgotten. Enter 9999 for the PIN code and select [Change PIN code]. The TV surrounds become warm. 1 Restart your TV by pressing the power button on the remote control until a message appears. The TV will restart.
Specifications System Panel system LCD (Liquid Crystal Display) Panel, LED Backlight TV system Depend on your country/area selection Analogue: B/G, I, D/K, M Digital: DVB-T/DVB-T2 Colour system PAL/SECAM/NTSC3.58/NTSC4.43 Channel coverage Depend on your country/area selection Analogue: UHF/VHF/Cable Digital: UHF/VHF Sound output 10 W + 10 W + 10 W + 10 W + 10 W + 10 W + 10 W + 10 W Wireless technology Protocol IEEE802.11ac/a/b/g/n (IEEE802.11ac may not be available depending on countries/regions.
Dimensions (Approx.) (w × h × d) Trademark Information with Floor Stand (KD-98Z9G only) • The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc. in the United States and other countries. • Dolby, Dolby Vision, Dolby Audio, and the double-D symbol are trademarks of Dolby Laboratories. Manufactured under license from Dolby Laboratories. Confidential unpublished works.
Help Guide http://rd1.sony.net/help/tv/gga2/h_ga/ © 2019 Sony Visual Products Inc.
