User Manual

000
Chapter 1: Introduction: Parts Identification
11
HDMI input connectors 3 and 4 (Type A)
Input HDMI signals.
When displaying data from a computer
during a presentation, for example,
connect to the computer via this
connector.
In addition, when compositing text using
an HDMI signal, connect to the computer
via this connector.
[Notes]
Proper operation may not be possible on some
connected devices (e.g., video or audio is not
output).
[Tips]

For input connectors 3 and 4, SDI and HDMI
signals cannot be input simultaneously from
identically numbered connectors. Only one of
the signals can be assigned for operation.

Copyright protected (HDCP) signals cannot be
input. (A black screen will be displayed.)
TITLE input connector (RGB, mini D-sub
15-pin)
Inputs an RGB signal.
When overlaying text created with a
computer to create a composite, connect
to the computer via this connector.
For details on overlaying text, see “Adjustments for
Inserting Text onto Videos” (page 47).
[Notes]
Only 1600×1200 (60p) signals are supported for
input. Use a computer that supports this output
resolution.
6. LINE (line) input connectors L and R
(balanced XLR 3-pin / TRS combo)
Input analog audio signals from an audio
mixer, for example.
7. LINE output connectors L and R (pin jacks)
Output PGM audio that was mixed down on
the unit.
8. PC UI network connector (RJ-45 modular
jack)
Connect the computer to be used for the PC
UI, which allows settings configuration and
control of the unit, here.
For details, see “Connecting a Computer for Settings
Conguration” (page 22).
9. STREAMING network connector (RJ-45
modular jack)
When streaming, connect to the network via
this connector.
For details, see “Chapter 5: Streaming” (page 58).
CAUTION
For safety, do not connect connectors for peripheral
device wiring that may have excessive voltage to the
following ports.
– PC UI network connector
– STREAMING network connector
Follow the instructions in this document for these ports.
CAUTION
When connecting the unit to a peripheral device via
a LAN cable, use a shielded-type cable to prevent
malfunction due to radiation noise.
10. MULTI VIEWER HDMI output connector
(Type A)
Connect the external monitor to be used for
the multi-viewer here.
For details, see “Multi-Viewer” (page 12).
For details on signal format settings for HDMI, see
“[Output] Screen” (page 69) in the "Conguring the
System Settings" section.
[Notes]

Proper operation may not be possible on some
devices (e.g., video or audio is not output).

Do not connect the output connectors on the unit to
those on an external device, as doing so will result in
malfunction.
11. DC IN 12V (DC power input) connector
Connect the supplied AC adapter here.
Be sure to use the nearby cable clamp to
prevent the cable from disconnecting.
Right Side
Terminal cover removed
1. USB port (Mini-B, USB 2.0)
Used for maintenance (e.g., system updates
and displaying licenses).