User Guide

Recording to MDs
13
GB
After recording
Press EJECT A to remove the MD or press
?/1 to turn off the deck.
“TOC” or “TOC Writing” starts flashing. The
TOC is updated and recording is completed.
Before disconnecting the mains lead
MD recording is completed when the MD Table
of Contents (TOC) is updated. The TOC is
updated when you eject the MD or press ?/1 to
turn off the deck. Do not disconnect the mains
lead before updating the TOC (while “TOC” is
lit) or while updating the TOC (while “TOC
Writing” is flashing) to ensure a complete
recording.
Automatic conversion of digital
sampling rates
A built-in sampling rate converter automatically
converts the sampling frequency of various
digital sources to the 44.1 kHz sampling rate of
the MD deck. This allows you to monitor and
record sources such as 32- or 48-kHz DAT tape
or satellite broadcasts, as well as the CDs and
MDs.
To prevent accidental erasure of the
recorded material
To protect an MD recording, slide the record-
protect tab in the direction of the arrow (see
illustration below) to open the slot. To enable
re-recording, close the slot.
All of the functions described here can be used
even when the Group function is on. For a
detailed description of the Group function, see
page 11.
Recording for long times
This deck has two long time recording modes:
LP2 and LP4 (MDLP recording). When
recording in LP2 Stereo mode, you can record 2
times the normal recordable time, and in LP4
Stereo mode, you can record 4 times the normal
recordable time. In addition, the recordable
time for monaural recording is approximately
double the stereo recording time.
LP4 Stereo mode (4× long time recording
mode) achieves a long stereo recording time by
use of a special compression system. When
placing emphasis on sound quality, Stereo
recording or LP2 Stereo recording (2× long
time recording mode) is recommended.
1 Do steps 1 to 4 of “Recording to an MD”
on page 10.
2 Press REC MODE repeatedly to select
the recording mode.
3 Do steps 5 to 7 of “Recording to an MD”
on page 10.
Notes on recording
Record-protect tab
Slide in the direction
of arrow
Recording tips
— Recording for long times/Marking
track numbers/Smart Space/Adjusting
the recording level/Checking the
remaining recordable time/Input
monitor
To record in Set REC MODE to
Stereo Blank (No indicator)
LP2 Stereo LP2
LP4 Stereo LP4
Monaural MONO
continued