User Guide

22
GB
Using the MD display
Press LEVEL/DISPLAY/CHAR (or DISPLAY)
repeatedly.
The display changes cyclically as follows:
Note
Note that, depending on the status of the deck, the
display may not conform with the cycle shown below.
During playing
Track name, track number and elapsed time of
the current track t Track name, track number
and remaining time of the current track t
Track name and remaining time of all recorded
tracks
1)
t Disc name and track name
2)
t
Level of the output signal t Pitch, track
number and elapsed time of the current track
1) When the Group function is on, the remaining
time of all tracks within the group is displayed.
2) “No Name” appears when the disc or track has no
name. When the Group function is on, the group
name and track name are displayed.
Turning off indications in the display
You can use Setup Menu to turn off the display during
playing. The display turns back on if you press x or
X.
1 While the deck is stopped or playing, press
MENU/NO.
2 Turn AMS (or press ./> repeatedly)
until “Setup?” appears, then press AMS or
YES.
3 Turn AMS (or press ./> repeatedly)
until “Display On” (factory setting) appears,
then press AMS or YES.
4 Turn AMS (or press ./> repeatedly)
to select “Display Off”, then press AMS or
YES.
5 Press MENU/NO.
To turn on the display, select “Display On” in step 4
above.
Tip
To check the track name during playing (only when
the track name is recorded)
, press SCROLL on the
remote. The track name appears and scrolls. While the
track name is scrolling, press the button again to pause
scrolling, and again to continue scrolling.
In stop mode
Disc name
1)
, total number of tracks and total
recorded time t Disc name
1)
, total number of
tracks and remaining recordable time
2)
on the
MD (recordable MDs only) t Level of the
input signal (setting value of the recording
level) t Pitch, total number of tracks and total
recorded time
1) “No Name” appears when the disc or track has no
name. When the Group function is on, the disc
name and the total number of groups (when no
group is selected) or the group name and the total
number of tracks and recorded time within the
group (when a group is selected) are displayed.
2) Time shown in the display differs depending on
the setting of REC MODE.