Quick Start Guide

7
Installing the unit
About the main power switch
Before installation, switch on the main power by
sliding the POWER switch to the ON position.
Thereafter, you can turn the unit on/off by
pressing ?/1 on the top right of the unit.
Notes
• Keep main power on unless the unit is not to be
used for more than 3 months.
• If you switch off the main power, it may take time to
receive GPS signals when switching on again.
About the suction mount
Before you start, choose a position on the
windscreen that is clearly visible to the driver
without obstructing the road view, and make sure
all surfaces are clean and dry.
The optional cradles NVA-CU3T/CU3 can also
be installed following the steps below.
Notes
• Install the unit in a safe place where it does not
interrupt the GPS signal.
• Detach and reattach the cradle regularly as cup
suction is affected by high/low temperature,
extended use, etc.
• Be sure to keep a distance between the cradle and
dashboard when installing.
1 Attach the cradle on the windscreen.
Figure example of completed cradle
installation
Follow steps 1 - 3 to complete.
1 Clean and dry the surface of the suction
cup.
2 Press the centre of suction cup firmly
against the windscreen to remove the
remaining air inside it, then press the lever.
3 Holding the left knob*, loosen the right
knob and set the approximate vertical
angle, then retighten.
*The left knob does not turn.
POWER
ONOFF
C
H
G
R
E
S
E
T
POWER
OFF
ON
continue to next page t
x
To tighten
To loosen