User Manual

Sony Corporation © 2003 Printed in Japan 4-677-222-01 (1)
PCGA-BA1 Series
Regulatory information
English
For customers in the U.S.A.
Owner’s Record
The model number is located on the bottom
of the adapter. Refer to this number
whenever you call your Sony dealer
regarding this product.
Model No. PCGA-BA1/A
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in
a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced
radio/TV technician for help.
The shielded interface cable recommended
in this manual must be used with this
equipment in order to comply with the limits
for a digital device pursuant to subpart B of
Part 15 of the FCC Rules.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
For questions regarding your product or for
the Sony Service Center nearest you, call 1-
888-476-6972 in the United States or 1-800-
961-7669 in Canada.
The number below is for FCC related
matters only.
Declaration of Conformity
Trade Name: Sony
Model No.: PCGA-BA1
Responsible Party:Sony Electronics Inc.
Address: 680 Kinderkamack Road Oradell,
NJ 07649 USA
Telephone No.: 201-930-6972
The device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Radio-Frequency Exposure Statement
This equipment generates and radiates radio-
frequency energy. In order to comply with
FCC radio-frequency radiation exposure
guidelines for an uncontrolled environment,
this equipment has to be installed and
operated while maintaining a minimum body
to antenna distance of 2.5 cm. Based on
continuous exposure of 30 minutes.
Users are not permitted to make changes or
modify the system in any way.