User Guide

4
6 Insert the headshell into the front of the tone arm.
Turn the locking collar in the direction of the
arrow until the headshell is secure.
7 Insert the hinges on the dust cover into the hinge
pockets on the rear of the cabinet.
3
4
7
5
6
1
2
Assembling the Turntable
1 If your turntable is equipped with a voltage
selector, be sure to set the selector to your line
voltage.
2 Carefully, place the platter on the spindle.
3 Using the ribbon, loop the drive belt around the
motor pully. After looping the belt, do not forget
to remove the ribbon.
4 Place the rubber mat on the platter.
5 Slide the counter weight onto the shaft at the rear
of the tone arm and turn 3 or 4 times in the
direction of the arrow.
Getting Started
110V·120V
220V·240V