User Manual

189
Additional Information
x Note on moisture condensation
Moisture may condense when you bring your
camcorder from a cold place into a warm place (or
vice versa) or when you use your camcorder in a
humid place as shown below.
• When you bring your camcorder from a ski
slope into a place warmed up by a heating
device.
• When you bring your camcorder from an air
conditioned car or room into a hot place outside.
• When you use your camcorder after a squall or a
shower.
• When you use your camcorder in a hot and
humid place.
x How to avoid moisture condensation
When you bring your camcorder from a cold place
into a warm place, put your camcorder in a plastic
bag and seal it tightly. Remove the bag when the
air temperature inside the plastic bag has reached
the ambient temperature (after about 1 hour).
LCD screen
• Do not exert excessive pressure on the LCD
screen, as it may cause damage.
• If your camcorder is used in a cold place, a
residual image may appear on the LCD screen.
This is not a malfunction.
• While using your camcorder, the back of the
LCD screen may heat up. This is not a
malfunction.
x To clean the LCD screen
The LCD screen is covered with a coating. The
coating may be peeled off by scratching or
rubbing. Maintain the LCD screen as follows.
• Wipe fingerprints or hand cream off the LCD
screen as soon as possible, as they may cause
the coating to peel off.
• If you rub the LCD screen hard, even with a
tissue, the coating may be damaged.
• Before wiping the LCD screen, blow dust or
sand off with a dust blower, etc.
• Wipe dirt off the LCD screen with a clean, soft
cloth, such as an eye glass cleaning cloth, etc.
About the display of the organic EL
panel
Because of the physical characteristics of the
organic EL panel, image persistence or low
brightness may occur.
These problems are not a malfunction, and the
organic EL panel can be used without problems.
Casing
• If the casing is soiled, clean the camcorder body
with a soft cloth lightly moistened with water,
and then wipe the casing with a dry soft cloth.
• Avoid the following to prevent damage to the
finish.
– Using chemicals, such as thinner, benzine,
alcohol, chemical cloths, repellent, insecticide
and sunscreen.
– Handling with above substances on your
hands.
– Leaving the casing in contact with rubber or
vinyl objects for a long period of time.
Care and storage of the lens
• Wipe the surface of the lens clean with a soft
cloth in the following instances: When there are
fingerprints on the lens surface. In hot or humid
locations When the lens is exposed to salty air,
such as at the seaside.
• Store in a well-ventilated location subject to
little dirt or dust.
• To prevent mold, periodically clean the lens as
described above.
Charging the pre-installed
rechargeable battery
Your camcorder has a pre-installed
rechargeable battery to retain the date, time,
and other settings even when the ON/
STANDBY switch is set to STANDBY.
The pre-installed rechargeable battery is
always charged while your camcorder is
connected to the wall outlet (wall socket)
via the AC Adapter or while the battery
pack is attached. The rechargeable battery
will be fully discharged in about 2 months
if you do not use your camcorder at all
without the AC Adapter connected or the
battery pack attached. Use your camcorder
after charging the pre-installed
rechargeable battery.
However, even if the pre-installed
rechargeable battery is not charged, the
camcorder operation will not be affected as
long as you are not recording the date.
Continued ,