Quick Reference Guide

Contents

Section Index

I. Recording, media and troubleshooting

Unable to enable MLUTS on the HDMI output in the

Cine EI mode: The MLUT can only applied to the HDMI

output if

(MENU: Video – Output Setting – HDMI Target)

is set to Monitor.

Unable to enable MLUTS for just SDI2, HDMI or the

Viewﬁnder: MLUT operation is limited to ON or OFF for

all outputs and internal recording in each of the following

situations: The HDMI output is set to 4K/UHD. S&Q Motion

is enabled. Lens distortion compensation is set to AUTO

(MENU: System – Lens – Distortion Comp).

Unable to view the Waveform, Vector or Histogram

in the Cine EI Mode: Both the SDI2/HDMI output and

Viewﬁnder MLUT settings must be the same.

Viewﬁnder Information overlays are not being

displayed: Press the “Display” button on the camera body

to turn the viewﬁnder and monitor overlays on and o.

System Reset: If the camera is not performing as

expected try a system reset to restore the factory defaults.