Operating Instructions
Table Of Contents
-  WARNING
- Compliance Information
- Before first use
- Connection/Installation
- Preparing the app and the batteries
- Mounting the RTK kit on the aircraft and assembling the aircraft
- Installing the base station
- Preparing the remote controller and the aircraft
- Preparing a camera
- Mounting the gimbal on the aircraft
- Mounting a camera on the gimbal (when using the GBL-PX1)
- Mounting a camera on the gimbal (when using the GBL-T3)
- Settings/Operation
- Storing
- Flight Information and Specifications
- Compliance Information
12
2 Remove the cables from the quick-release ports.
Power cable
(aircraft — gimbal)
USB Type-C® cable
(aircraft — gimbal)
Control cable
(aircraft — gimbal)
Note
A locking mechanism is used on the control cable (aircraft — gimbal) and power cable (aircraft — gimbal). To
release the lock, hold down the locking tab and pull out the cable.
Hold down the locking tab
and pull out the cable.
3 Remove the hex screws that secure the damping plate to the aircraft.
Remove the hex screws with the hex wrench (H2.5 mm) (0.1 in.) included in the gimbal set
(sold separately).
Remove at two positions on
each leg (eight total).