Operating Instructions
Table Of Contents
-  WARNING
- Compliance Information
- Before first use
- Connection/Installation
- Preparing the app and the batteries
- Mounting the RTK kit on the aircraft and assembling the aircraft
- Installing the base station
- Preparing the remote controller and the aircraft
- Preparing a camera
- Mounting the gimbal on the aircraft
- Mounting a camera on the gimbal (when using the GBL-PX1)
- Mounting a camera on the gimbal (when using the GBL-T3)
- Settings/Operation
- Storing
- Flight Information and Specifications
- Compliance Information
15
Connection/Installation
Note
A locking mechanism is used on the control cable (aircraft — gimbal) and power cable (aircraft — gimbal). To
release the lock, hold down the locking tab and pull out the cable.
Hold down the locking tab
and pull out the cable.
2 Remove the M2 screws that secure the connection hub to the aircraft.
Keep the M2 screws that you removed from the connection hub, as they will be used later.
Remove at two positions.
3 Remove the connection hub from the aircraft.