Operating Instructions
Table Of Contents
-  WARNING
- Compliance Information
- Before first use
- Connection/Installation
- Preparing the app and the batteries
- Mounting the RTK kit on the aircraft and assembling the aircraft
- Installing the base station
- Preparing the remote controller and the aircraft
- Preparing a camera
- Mounting the gimbal on the aircraft
- Mounting a camera on the gimbal (when using the GBL-PX1)
- Mounting a camera on the gimbal (when using the GBL-T3)
- Settings/Operation
- Storing
- Flight Information and Specifications
- Compliance Information
16
[3] Attaching the interface unit to the aircraft
1 Place the interface unit on the aircraft.
With the arrow indicating FRONT () pointing toward the front of the aircraft, place the
interface unit on the aircraft connector. Push the interface unit fully until they are connected.
FRONT
2 Secure the interface unit to the aircraft.
Secure the interface unit to the aircraft with the M2 screws removed in “[2] Removing the
connection hub from the aircraft.”
FRONT
Secure at two positions.
Note
When securing the interface unit to the aircraft, be sure to tighten the M2 screws with a torque of 0.2 ±0.06 Nm.
¼
Hint
If the removed M2 screws become lost, use the M2 screws included with this product.